JeffTron Mosfet Version 3 for Airsoft AEG's Model: w/ Rear Wiring

Description

Features

Very small device dimension - uses Micro Mosfet II
Prepared wiring allows fast and easy installation into your pistol. Simply solder wires to the motor and trigger contacts
On the devices are pre-soldered high quality wiring 0.5 mm (AWG20) with silicone insulation (length 210mm from mosfet) and blue wires 0.25 mm (AWG24) with PVC insulation (length 110mm from mosfet)
Can be used with any AEP upgrade, because it was designed for spring up to M160 (equivalent for current 75A single shot fire or 25A burst fire for max. 30s)
Recommended to use 7.4V LiPo battery, but device is specified for common batteries up to 17V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V)
No current consumption in the idle mode
No sparking on switch contacts

Professionally made mosfet designed for airsoft electric pistols (AEP).
Device increases gun rate of fire and battery holds longer than with basic wiring.

Can be installed without modifications into these AEP:

Cyma CM.030 18C
Cyma CM.121 Desert Eagle
Cyma CM.122 P226
Cyma CM.123 M1911
Cyma CM.125 USP
Cyma CM.126 M92F
Cyma CM.127 Phantom
Cyma CM.128 HI-CAPA 5.1
Tokyo Marui 18C AEP
Tokyo Marui M93R AEP
Tokyo Marui M9A1 AEP
Tokyo Marui USP AEP
Umarex HK USP AEP
Double Eagle M81

Maximum Input Voltage: 17V
Compatibility: For Airsoft AEP Gearboxes

Manufacturer: JeffTron

JeffTron Mosfet Version 3 for Airsoft AEG's Model: w/ Rear Wiring

JeffTron